Dell PowerVault MD3000 - Manual (Page 8)

Dell MD Storage Array vCenter Plug-in | 8
2
Configuring the Application Server and
the vCenter Plug-In
After the application server and the vCenter Plug-in were installed, verify that the vCenter Plug-in was
successfully registered with the vCenter server.

Open the vSphere Client to the vCenter Server.

On the menu bar, select Plug-ins->Manage Plug-ins.

The Dell MD Storage Array vCenter Management Plug-in is listed as Enabled.

However if the vCenter Plug-in is listed as disabled with an error message stating that it cannot
communicate with the application server, verify that the port number defined for the Jetty server is
enabled to pass through any firewalls that might be in use. The default Jetty TCP port number is 8084
and 8081.
After the application server and vCenter server have been configured, the Dell MD Storage Array vCenter
Management vCenter Plug-in icon appears in the Solution and Application section of the vSphere Client
page.
Figure 2 vSphere Client Home Page