Dell PowerEdge 1600SC - Manual (Page 12)

Figure 1 -5 shows the back-panel features of the system.
Figure 1-5. Back-Panel Features
Connecting External Devices
When connecting external devices to your system, follow these guidelines:
l Most devices must be connected to a specific connector and device drivers must be installed before the device will operate properly. (Device drivers are
normally included with your operating system software or with the device itself.) Check the documentation that accompanied the device for specific
installation and configuration instructions.
l Always attach external devices while your system is turned off. Then turn on any external devices before turning on the system (unless the
documentation for the device specifies otherwise). If the system does not appear to recognize the device, try turning on the system before turning on
the device.
For information about individual connectors, see "I/O Ports and Connectors" in your Installation and Troubleshooting Guide. For information about enabling,
disabling, and configuring I/O ports and connectors, see "
Using the System Setup Program ."
System Features
Your system offers the following features:
l Up to two Intel® Xeon™ microprocessors with a speed of at least 1.8 GHz, a front side bus speed of at least 400 MHz, and a 512-KB Level 2 cache
l A minimum of 128 MB of ECC DDR 266 SDRAM memory, upgradable to a maximum of 4 GB by installing 128-, 256-, 512-MB, or 1-GB registered memory
modules in the four memory module sockets on the system board
l Support for the following internal hard-drive configurations:
¡ Up to six 1-inch Ultra3 SCSI hot-plug hard drives
¡ Up to four 1-inch non-hot-plug SCSI or IDE hard drives
l Integrated SCSI controller for SCSI hard drives and integrated IDE controller for IDE hard drives, CD drive, and optional DVD and combination drives
NOTE: Figure 1 -5 shows a system with optional redundant AC power supplies installed.
NOTE: Use the System Setup program to view microprocessor information. For more information, see " Using the System Setup Program ."