Dell OptiPlex Gxi - Manual (Page 50)

3-6 Dell OptiPlex GX i Midsize Systems Reference and Installation Guide
Figure 3-5. Available Settings List Box
9. To change individual resource values for the cur-
rent configuration setting, select the resource
value that you want to change and click the
Options button located below the resource values
(see Figure 3-6).
For example, when you click the value under DMA ,
the Options button changes to the DMA Options but-
ton. When you click this button, a smaller dialog box
appears. By clicking the down arrow next to the cur-
rent resource value, you can display a list of the
available values for the resource.
Figure 3-6. Configuration Settings Dialog
Box
Choose the desired value and click OK. The value
you selected is displayed under the resource heading
in the Configuration Settings dialog box.
The Options button is disabled if no alternative val-
ues are available for the selected resource.
NOTE: If you change one or more resource values
using the Options button and later change the setting
in the Configuration Choice box, the changes that
you made to the resource values are overwritten by
the default values for the new configuration choice.
10. Click OK in the Configuration Settings dialog
box when you have finished selecting resources
for the function.
NOTE: After modifying the system configuration, you
must turn off the system to install, remove, or change
jumper settings on the non-Plug and Play ISA expansion
cards to match the settings you selected in the ICU.
A
dding an Unlisted Card
Unlisted cards are non-Plug and Play ISA expansion
cards that do not have configuration files stored in the
ICU database.
NOTE: If you want to add a configuration file that you
received on diskette with a new expansion card, see
“Adding a Listed Card” found earlier in this chapter.
To add an unlisted card with the ICU, perform the follow-
ing steps:
1. Start the ICU as described in “Starting the ICU”
found earlier in this chapter.
2. From the ICU window, click Add or select ADD
CARD from the Configure menu.
3. Click the name of the category of card that you
want to add. If you clicked Add in step 2, click
OK.
A dialog box appears listing the names of all avail-
able cards of that type.
4. Select UNLISTED CARD from the bottom of the list
of cards displayed in the dialog box that appears.
Then click OK.
5. Click No when the ICU asks if you have a config-
uration file for the card.
The Configure Unlisted Card dialog box appears
with blank fields.
6. Enter the name of the card that you want to add
in the
CARD NAME field.
7. For each resource you want to assign to the card,
click the box beneath the name of the resource to
be assigned and then click Add.
For example, if you click the box beneath INTER-
RUPT (IRQ) , the button changes to Add Interrupt.
When you click this button, a Specify dialog box (in
this case, Specify Interrupt) appears. Figure 3-7
shows the Configure Unlisted Card dialog box with
the Specify Interrupt dialog box opened.