Replacing the display assembly – Dell Inspiron 1420 (Mid 2007) User Manual
Page 14
11.
Remove the four M2.5 x 5-mm screws (one on each side of the main battery bay and one below each hinge cover) that connect the display assembly to
the computer.
12.
Lift the display assembly straight up and out of the computer.
Replacing the Display Assembly
1.
Follow the instructions in
Before You Begin
2.
Follow the instructions in
3.
Align the new display assembly over the screw holes in the base of the computer.
4.
Replace the two M2.5 x 5-mm screws marked D (one on each side of the main battery bay) to secure the display assembly to the base of the computer.
5.
Carefully route the Mini-Card antenna cables through the cable guide on the base of the computer.
1
media buttons board
2
screw
3
grips (5)
1 screws (2)
2 main battery bay
3 bottom of the system
1
screws (2)
2
back of the system
3
hinge covers (2)
CAUTION:
Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface, such
as the back panel on the computer.