Dell Latitude 120L - Manual (Page 18)

6. Press in both sides of the top flex-cable connector, and pull the top flex-cable connector away from the display connector.
7. Use the pull-tab to disconnect the bottom flex-cable connector from the inverter connector.
Replacing the Display Panel
1. Connect the top flex-cable connector to the display panel connector.
2. Connect the bottom flex-cable connector to the inverter connector.
3. Lay the display panel into the top cover.
4. Replace the eight M2 x 3-mm screws that secure the display panel to the top cover.
5. Route the display-feed flex cable so that it rests in the notch located in the bottom edge of the top cover.
6. Replace the display bezel.
Back to Contents Page
1 display panel 2 top cover 3 M2 x 3-mm screws (8)
1 inverter connector 2 pull-tab on bottom flex-cable connector 3 top flex-cable connector
4 display connector