Mini pci card, Replacing the optical drive, Removing the mini pci card – Dell Latitude 120L User Manual
Page 40
1.
Close your display and turn the computer upside-down.
2.
If a device security screw is present, use a Phillips screwdriver to remove the M2.5 x 8-mm screw.
3.
Using a screwdriver or a plastic scribe, push the notch by the device security screw hole toward the outside of the computer.
4.
Pull the optical drive straight out of the media bay.
Replacing the Optical Drive
1.
Slide the new drive into the bay until it snaps securely into place.
2.
If you removed the M2.5 x 8-mm device security screw, replace it.
3.
Turn the computer top-side up and open the display.
4.
The operating system automatically recognizes the device. If necessary, enter your password to unlock your computer.
Mini PCI Card
Removing the Mini PCI Card
If you ordered a Mini PCI card with your computer, the card is already installed.
1.
Follow the instructions in
Before Working Inside Your Computer
.
2.
Turn the computer upside-down, loosen the captive screws on the memory module/Mini PCI cover, and then remove the cover.
1 optical drive 2 drive removal slot
3 M2.5 x 8-mm device security screw (if present)
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE:
To prevent damage to the system board, remove the main battery before working inside the computer.