Dell Precision M2400 (Mid 2008) - Manual (Page 41)

Troubleshooting
41
2 Turn on (or restart) your computer.
3 When the DELL™ logo appears, press <F12> immediately. Select
Diagnostics from the start menu and press <Enter>.
NOTE:
If you wait too long and the operating system logo appears, continue to
wait until you see the Microsoft
®
Windows
®
desktop, and then shut down
your computer and try again.
NOTE:
If you see a message stating that no diagnostics utility partition has
been found, run the Dell Diagnostics from the Drivers and Utilities media.
4 Press any key to start the Dell Diagnostics from the diagnostics utility
partition on your hard drive, and follow the instructions on the screen.
Starting the Dell Diagnostics From the Drivers and Utilities Media
1 Insert the Drivers and Utilities media.
2 Shut down and restart the computer.
When the DELL logo appears, press <F12> immediately.
NOTE:
If you wait too long and the operating system logo appears, continue
to wait until you see the Microsoft
®
Windows
®
desktop; then, shut down your
computer and try again.
NOTE:
The next steps change the boot sequence for one time only. On the
next start-up, the computer starts according to the devices specified in the
system setup program.
3 When the boot device list appears, highlight CD/DVD/CD-RW and press
<Enter>.
4 Select the Boot from CD-ROM option from the menu that appears and
press <Enter>.
5 Type
1 to start the CD menu and press <Enter> to proceed.
6 Select Run the 32 Bit Dell Diagnostics from the numbered list. If
multiple versions are listed, select the version that is appropriate for your
computer.
7 When the Dell Diagnostics Main Menu appears, select the test that you
want to run, and follow the instructions on the screen.
book.book Page 41 Tuesday, July 22, 2008 10:56 AM