Dell Dimension 9100 - Manual (Page 27)

6. While pushing on the back of the drive, remove the Media Card Reader by sliding and holding the sliding plate.
7. Replace the drive panel .
8. Replace the computer cover .
Installing a Media Card Reader
1. Follow the procedures in " Before You Begin ."
2. Lay the computer on its side so that the system board is on the bottom of the inside of the computer.
3. Remove the computer cover .
4. Remove the drive panel .
5. Remove the Media Card Reader from its packaging and ensure that all four screws are included.
6. Gently slide the drive into place until you feel a click or feel the drive securely installed.
Ensure that the Media Card Reader is installed before the FlexBay cable is connected.
7. Connect the FlexBay USB cable to the back of the Media Card Reader and to the Media Card Reader connector on the system board (see " System Board
Components ").
8. Insert the Media Card Reader into the bay and slide the drive in to seat it in the computer.
9. Route the USB cable through the cable routing clip.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.