Internal card with bluetooth® wireless technology, Removing the internal card, Replacing the internal card – Dell Inspiron 9200 User Manual
Page 28
Back to Contents Page
Internal Card with Bluetooth® Wireless Technology
Dell™ Inspiron™ 9200
Removing the Internal Card
1.
Follow the instructions in "
Before Working Inside Your Computer
."
2.
Remove the battery.
3.
Remove the M2.5 x 8-mm screw and remove the card cover from the computer.
4.
Pull the card out of the compartment so that you can disconnect the card from its cable and remove it from the computer.
Replacing the Internal Card
1.
To replace the card, connect the card to the cable and then carefully insert it into the compartment.
2.
Replace the card cover and the screw.
3.
Replace the battery.
Back to Contents Page
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE:
To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.
NOTE:
If you ordered a Bluetooth card with your computer, the card is already installed.
1 Bluetooth card door
2 Bluetooth card
3 Bluetooth card connector