Dell Latitude CPx H - Manual (Page 29)

22 Dell Latitude CPt V/CPt S Series and CPx H/CPx J Series Service Manual
3. Use a scribe to carefully pry the two plastic screw covers out of the two
screw holes located at the bottom of the bezel on the front of the display
assembly.
4. Remove the two 4-mm screws from the bottom of the bezel.
127,&( 7KHEH]HOWDEVDUHIUDJLOH+DQGOHWKHEH]HOFDUHIXOO\WR
DYRLGEUHDNLQJWKHSODVWLFWDEVRII
5. Separate the bezel from the display-assembly top cover.
The bezel is secured by three plastic tabs on the left and three plastic tabs
on the right side of the display-assembly top cover (see Figure 14).
5HPRYLQJWKH,QFK/&'3DQHO
1. Remove the display assembly bezel.
2. Remove the three 3-mm screws on the left side of the LCD panel and the
three 3-mm screws on the right side of the LCD panel (see Figure 14).
3. Lift and rotate the top of the LCD panel out of the top cover. Disconnect
the ZIF interface connector and the display-assembly interface cable
connector.
4. Lift the LCD panel out of the top cover.
5HPRYLQJWKH,QFK/&')OH[&DEOH
127,&( 0DNHVXUHWKDWWKHZRUNVXUIDFHLVFOHDQWRSUHYHQWVFUDWFK
LQJWKHFRPSXWHUFRYHU
1. Remove the LCD panel.
2. Turn the display assembly upside down on a flat work surface.
3. Remove the 4-mm screw securing the metal cable clip to the left hinge of
the display-assembly top cover.
4. Remove the flex cable out from under the plastic strain relief retainer
located on the bottom of the display-assembly hinge cover.
5. Remove the flex-cable retaining clip from the bottom of the hinge cover
located at the bottom of the display-assembly hinge cover.
6. Pry the hinge-cover assembly apart slightly from the display assembly,
allowing just enough space for the flex cable to pass through the opening.
7. Slide the cable through the opening.