Chicago Electric 98107 - Manual (Page 15)

Page 15 For technical questions, please call 1-800-444-3353. SKU 98107
work piece and work area set up
Designate a work area that is clean 1.
and well-lit. The work area must not
allow access by children or pets to
prevent injury and distraction.
Route the power cord along a safe
2.
route to reach the work area without
creating a tripping hazard or exposing
the power cord to possible damage.
The power cord must reach the work
area with enough extra length to al-
low free movement while working.
Secure loose work pieces using a
3.
vise or clamps (not included) to pre-
vent movement while working.
There must not be hazardous ob-
4.
jects, such as utility lines or foreign
objects, nearby that will present a
hazard while working.
You must use personal safety equip-
5.
ment including, but not limited to,
ANSI-approved eye and hearing pro-
tection, as well as heavy work gloves.
Before beginning work, provide for
6.
sparks and debris that will fly off the
work surface.
general Operating instructions
tO preVent
seriOus injurY:
Grip the tool firmly in both
hands.
Press the Switch down and forward 1.
to start the tool.
Allow the tool to come up to full
2.
speed before touching the work ma-
terial.
Apply the wheel to the work mate-
3.
rial, allowing the tool to operate at
full speed. If the tool bogs down, use
lighter pressure.
To create a smoother surface, keep
4.
the tool moving over the work sur-
face.
Pull the Switch back to stop the tool.
5.
Allow the tool to come to a complete 6.
stop before setting it down.
To prevent accidents, turn off the tool
7.
and disconnect its power supply after
use. Clean, then store the tool in-
doors out of children’s reach.
reV 09f