Dell PowerVault MD3820f - Manual (Page 11)

11
Default IPv4 settings for the iSCSI Ports on MD38x0i
array
NOTE: No default gateway is set.
By default, the iSCSI ports on the storage array are set to the following static IPv4 settings:
Table 6. Default iSCSI Port IPv4 Addresses on MD38x0i Storage Arrays
Controller/Port (MD38x0i) IPv4 address Subnet Mask Port #
Controller 0, Port 0 192.168.130.101 255.255.255.0 3260
Controller 0, Port 1 192.168.131.101 255.255.255.0 3260
Controller 1, Port 0 192.168.130.102 255.255.255.0 3260
Controller 1, Port 1 192.168.131.102 255.255.255.0 3260
Supported RAID Controller Firmware and NVSRAM
NOTE: It is advisable to gather support information before performing any
firmware upgrade.
NOTE: Only drivers and firmware released by Dell are supported. For the latest
driver and firmware releases, see the Downloads section at
support.dell.com.
Table 7. Latest RAID Controller Firmware and NVSRAM Versions
Software Version
RAID Controller
Firmware
08.20.05.60
RAID Controller
NVSRAM
N2701-820890-004
Supported iSCSI Software Initiators
Table 8. Supported iSCSI Initiators
Operating System SW Initiator Vendor SW Initiator Version Notes
Windows Server OS Microsoft RTM or later Included w/OS
Red Hat Enterprise Linux Red Hat RTM or later Included w/OS
SUSE Linux Enterprise Server SUSE RTM or later Included w/OS
VMware ESX VMware RTM or later Included w/OS