Dell POWEREDGE M1000E - Manual (Page 45)

Initial System Configuration 45
NOTE: Components not appearing in the above table require no updates to enable
the FlexAddress feature.
Activating FlexAddress Plus
FlexAddress Plus is delivered on the FlexAddress Plus Secure Digital (SD)
card along with the FlexAddress feature.
NOTE: The SD card labeled FlexAddress only contains FlexAddress and the card
labeled FlexAddress Plus contains FlexAddress and FlexAddress Plus. The card
must be inserted into the CMC to activate the feature.
The updates, which are listed in the table below include, BIOS, iDRAC, and
CMC firmware. As long as FlexAddress is activated, you must apply these
updates before you can use FlexAddress Plus. If these updates are not applied,
only FlexAddress works and not FlexAddress Plus.
For more information on the FlexAddress feature, see the following resources:
• The CMC Secure Digital (SD) Card Technical Specification document at
support.dell.com.
• The Help link in the CMC Web interface.
• The "Using FlexAddress" chapter in the CMC User’s Guide.
CMC Version 1.10 or later
Component Minimum required version
Server Module BIOS PowerEdge M710HD
iDRAC Version 3.0 or later
CMC Version 3.0 or later
Component Minimum Required Version
book.book Page 45 Wednesday, March 9, 2011 3:11 PM