Display latch, Replacing the display panel, Removing the display latch – Dell Latitude 131L User Manual
Page 20: Replacing the display latch
Replacing the Display Panel
1.
Reconnect the top display-cable connector to the top flex-cable connector.
2.
Reconnect the bottom flex-cable connector to the inverter connector.
3.
Replace the display panel inside the display back cover.
4.
Replace the eight M2 x 3-mm screws (four on each side) in order around the display panel.
5.
Replace the display bezel (see
).
Display Latch
Removing the Display Latch
1.
Follow the instructions in
Before You Begin
.
2.
Remove the display assembly (see
).
3.
).
4.
Slide the latch to the right and gently lift.
5.
Remove the spring that attaches the latch to the display panel.
Replacing the Display Latch
1 pull-tab on bottom flex-cable
connector
2 top flex-cable
connector
3 display cable
connector
4 inverter connector
NOTE:
The eight screw locations are numbered. Replace the screws in sequential order.
CAUTION:
Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE:
To help prevent damage to the system board, you must remove the main battery (see
Before Working Inside Your Computer
) before you
begin working inside the computer.
1
spring
2
display latch