Display assembly, Removing the display assembly – Dell Latitude D631 (Early 2009) User Manual
Page 11
Back to Contents Page
Display Assembly
Dell™ Latitude™ D631 Service Manual
Removing the Display Panel Brackets
Removing the Display Panel Cable
Removing the Display Assembly
1.
Follow the instructions in
Before You Begin
.
2.
Remove the hinge cover (see
Hinge Cover
).
3.
Remove the keyboard (see
Removing the Keyboard
).
4.
Review the cable routing diagram:
5.
Pull straight up on the pull tab that is attached to the display cable to disconnect the cable from the system board.
6.
Disconnect the antenna cables from their card(s) (see
Communications Cards
).
7.
Carefully remove the antenna cables and the display cable from their routing guides.
8.
Close the display.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface, such as a connector on the back of the computer.
1 WWAN card connector
2 WWAN antenna cables
3 WLAN antenna cables
(black and white)
4 WLAN card
5 pull tab
6 display cable
7 WLAN antenna cables
(white and gray)
8 WLAN antenna cable
(currently unused) (gray)
NOTICE:
To avoid damage to your computer, use the illustration above when replacing the display assembly to carefully reroute the cables in the
appropriate cable channels. Route the gray and black antenna cables beneath the white antenna cable, and the black display cable on top of the white
antenna cable.