Dell PowerVault MD3260i - Manual (Page 9)

Upgrading From A Previous Version
If you are upgrading from a previous version of the MD vCenter Plug-in but plan to use the same host
server as the application server, run the latest installer on the current application server. The installation
wizard will prompt for an administrator password before unregistering and upgrading your MD vCenter
Plug-in version.
Application Server Requirements
The Windows-based application server configured with vCenter Client should be installed on a separate
server installation than the one running vCenter Server. While it is possible to install the application server
and vCenter Server on the same host, it is not recommended.
Before You Install The MD vCenter Plug-In
Before installing the MD vCenter Plug-in, you need to know some specific information about your
storage array and network configuration. The following table shows the information you will need. Gather
this information about your specific environment before installing the MD vCenter Plug-in:
Table 1. Storage Array and Network Information
Component Information Needed
vCenter Server Host Name:
DNS Names:
IP Addresses:
vCenter Administrator Username:
Password:
Storage Administrator Username:
Password:
Application Server Host Name:
DNS Names:
IP Addresses:
MD Storage Array Array Name:
Password:
IP Addresses:
MD Storage Array Array Name:
Password:
IP Addresses:
9