Dell Precision M65 - Manual (Page 63)

4. Ground yourself by touching one of the metal connectors on the back of the computer.
5. If a card is not already installed, go to step 6 . If you are replacing a card, remove the existing card:
a. Disconnect the antenna cables from the card.
b. Release the card by spreading the metal securing tabs until the card pops up slightly.
c. Lift the card out of its connector.
6. Install the card:
a. Align the card with the connector at a 45-degree angle, and press the card into the connector until it clicks.
b. Connect the antenna cable or cables to the Mobile Broadband card, ensuring that you route the cables correctly.
Internal Card With Bluetooth® Wireless Technology
NOTE: If you leave the area, ground yourself again when you return to the computer.
1 antenna cables
1 Mobile Broadband card 2 metal securing tabs (2)
NOTICE: The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors and realign the card.
NOTICE: To avoid damaging the Mobile Broadband card, never place cables on top of or under the card.
NOTE: Most connectors have color-coded markings that correspond to the type of cable required. For more specific information about which cable to
connect to which connector, see the documentation that came with your Mobile Broadband card.
CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of
the computer.
NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.