Dell PowerEdge SC1420 - Manual (Page 3)

Installing the Bezel
1. Align the seven bezel release tabs with the system.
2. Press the bezel onto the system until it snaps into place.
3. Install all the drives that you removed.
4. Close the system.
5. Reconnect the system to the electrical outlet, and turn on the system.
Control Panel
You must remove the bezel to access the control panel.
Removing the Control Panel
1. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2. Open the system.
3. Remove the bezel. See " Removing the Bezel ."
4. Disconnect the control panel cable from the I/O panel. See Figure 1 -3 .
5. Using a #2 Phillips screwdriver, remove the screw that secures the control panel to the front panel. See Figure 1 -2 .
Figure 1-2. Removing and Installing the Control Panel
CAUTION: See your System Information Guide for complete information about safety precautions, working inside the computer, and protecting
against electrostatic discharge.