Client system requirements, Deep s4/s5, Identify protection technology (ipt) – Dell Latitude E6320 (Early 2011) User Manual
Page 3
ME answers LAN ARP request (IPV4) & Neighbor Discovery packets (IPV6) by not waking and instead notifying the console
system in Sx.
New Win7 LAN requirement
Only for 5MB SKU and in Power Policy 2
Deep S4/S5
This is automatically disabled when AMT is provisioned in PP2.
Identify Protection Technology (IPT)
Enable One Time Password based secure login and web transactions via ME-based authentication.
Client System Requirements
The client system referred to in this document is based on the Intel 6 Series Chipset Family/Intel PCH platform, and is
managed by Intel Management Engine. The following firmware and software requirements are required for the installation and
setup before the Intel Management Engine can be configured and run on the client system.
An SPI flash device programmed with Intel AMT 7.0 flash image integrating BIOS, Intel Management Engine and GbE
component images.
BIOS set up with Intel AMT enabled, can access MEBx setup from F12 menu.
To enable all the Intel Management Engine features within Microsoft Operating System, the device drivers (Intel
MEI/SOL/LMS) must be installed and configured on the client system.
*
Information on this page provided by
.
NOTE:
The Intel Management Engine BIOS Extension (MEBx) is an optional ROM module provided to Dell
™
from Intel
that is included in the Dell BIOS. The MEBx has been customized for Dell computers.