Dell Precision M3800 (Late 2013) - Manual (Page 24)

Installing the Heatsink
1. Align the screw holes on the heatsink with the screw holes on the system board.
2. Tighten the screws to secure the heatsink to the system board.
3. Install the:
a. battery
b. base cover
4. Follow the procedures in After Working Inside Your Computer.
Removing the Power Connector
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the:
a. base cover
b. battery
3. Disconnect the following cables from the system board:
a. power connector
b. touch panel
4. Perform the following steps to remove the power connector.
a. Release the power connector cable from under the display hinge [1].
b. Remove the screw that secures the power connector to the palmrest assembly.
c. Lift the power connector off the palmrest assembly [2].
Installing the Power Connector
1. Tighten the screw to secure the power connector to the palmrest assembly.
2. Route the power connector cable under the display hinge.
24