Dell Precision M3800 (Late 2013) - Manual (Page 28)

Installing the System Board
1. Align the system board on the computer.
2. Tighten the screws and the captive screws to secure the system board to the computer.
3. Slide the keyboard cable in the connector and press down on the connector latch to secure the
cable.
4. Adhere the tape to the keyboard-cable connector.
5. Route the following cables on the system board and press down on the connector latches to secure
the cables:
a. speaker
b. keyboard (affix the tape)
c. touchpad
d. keyboard backlight
6. Connect the following cables to the system board:
a. display
b. hard drive
c. touch panel
d. power connector
CAUTION: Make sure that no cables are placed under the system board.
7. Install the:
a. memory module(s)
b. mSATA card
c. heatsink
d. fans
e. battery
f. base cover
8. Follow the procedures in After Working Inside Your Computer.
Removing the Keyboard
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the:
a. base cover
b. battery
c. fans
d. heatsink
e. mSATA card
f. memory module(s)
g. system board
h. hard drive
28