Dell Alienware M14x (Early 2011) - Manual (Page 23)

Back to Contents Page
Center-Control Cover
Alienware® M14x Service Manual
Removing the Center-Control Cover
Replacing the Center-Control Cover
Removing the Center-Control Cover
1. Follow the instructions in Before You Begin .
2. Remove the base cover (see Removing the Base Cover ).
3. Remove the battery pack (see Removing the Battery Pack ).
4. Remove the three screws that secure the center-control cover to the computer base.
5. Turn the computer over and open the display as far as possible.
6. Gently pry the center-control cover and then ease the tabs on the center- control cover out of the slots on the palm-rest assembly.
7. Lift the center-control cover off the computer base.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is
not covered by your warranty.
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery Pack ) before working inside the
computer.
1 screws (3)