Dell Latitude C810 - Manual (Page 24)

b. Ensure that the slider is inserted so that the side with the two bumps is facing the back of the case, and the surface with the wear ribs is facing
the bottom of the case.
7. Hold the upper latch assembly in place while you snap the new latch button in from underneath the base, making certain the snap tabs are fully
engaged in the slider.
8. Ensure that the newly installed latch assembly moves smoothly and freely when pushed and released.
Battery Charger Board
Battery Charger Board
Removing the Battery Charger Board
1. Follow the instructions in "Preparing to Work Inside the Computer ."
2. Remove the keyboard.
3. Remove the hinge cover .
4. Remove the display assembly .
5. Remove the palmrest assembly .
6. Remove the video graphics board .
7. Lift the battery charger board out of the system board connector.
Replacing the Battery Charger Board
Align the screw holes on the battery charger board with the screw holes on the bottom case assembly (see Battery Charger Board), and then press the
battery charger board down into its connector.
LED Board
LED Board
NOTICE: Disconnect the computer and attached devices from electrical outlets and remove any installed batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by periodically touching unpainted metal on the computer.
NOTICE: Disconnect the computer and attached devices from electrical outlets and remove any installed batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by periodically touching unpainted metal on the computer.