Mini pci card assembly, Removing the mini pci card assembly, Replacing the mini pci card assembly – Dell Latitude C810 User Manual
Page 8
3.
Lift the memory module out of its socket.
Replacing the Memory Modules
1.
If you only have one memory module, install it in the socket labeled "DIMM A." Install a second memory module in the socket labeled "DIMM B."
2.
Insert the memory module's edge connector into the socket slot at a 45-degree angle and press the module firmly into the slot.
3.
Pivot the module down until it clicks into place. If you do not hear a click, remove the module and reinstall it.
4.
Insert the metal tabs on the memory module cover into the bottom case assembly, rotate the cover down, and replace the screw.
Mini PCI Card Assembly
You must remove the optional Mini PCI Card assembly before the system board assembly can be removed. A Mini PCI Card assembly may consist of a modem,
a NIC, a modem and NIC combination, or a wireless NIC. A modem, NIC, or modem and NIC combination must be connected to the wiring harness as
appropriate; a wireless NIC must be connected to the system's internal antenna.
Mini PCI Card Cover
Removing the Mini PCI Card Assembly
1.
Follow the instructions in
"Preparing to Work Inside the Computer
."
2.
Remove the Mini PCI Card cover.
3.
To release the Mini PCI Card assembly, spread the metal securing tabs until the assembly pops up slightly.
4.
Disconnect the assembly from the wiring harness or internal antenna.
5.
Lift out the assembly and disconnect any attached cables.
Replacing the Mini PCI Card Assembly
1.
Align the Mini PCI Card assembly with the socket at a 45-degree angle, and press the Mini PCI Card into the socket.
2.
Depending on what type of Mini PCI Card you are installing, either connect the wiring harness to the Mini PCI Card assembly, or connect the mini-coax
antenna cable from the Mini PCI Card assembly to the internal antenna.
Mini PCI Card Assembly Using Wiring Harness
NOTE:
Memory modules are keyed to fit into their sockets in only one direction.
NOTICE:
Disconnect the computer and attached devices from electrical outlets and remove any installed batteries.
NOTICE:
To avoid ESD, ground yourself by using a wrist grounding strap or by periodically touching unpainted metal on the computer.
NOTICE:
The connectors are keyed for correct insertion; do not force the connections.