Removing the stand, Attaching the dell soundbar (optional), Removing the monitor stand – Dell IN1930 Monitor User Manual
Page 36: Attaching the dell soundbar
To connect your monitor to the computer:
1.
Turn off your computer and disconnect the power cable.
2.
Connect either the white (digital DVI-D) or the blue (analog VGA) display connector cable to the corresponding video port on the back of your
computer. Do not use both cables on the same computer. Use both the cables only when they are connected to two different computers with
appropriate video systems.
Connecting the Blue VGA Cable
Connecting the white DVI cable (for IN2030M only)
Removing the Monitor Stand
Attaching the Dell Soundbar
WARNING:
Before you begin any of the procedures in this section, follow the
Safety Instructions
.
CAUTION: The graphics are used for the purpose of illustration only. Appearance on the computer may vary.
After placing the monitor panel on a soft cloth or cushion, complete the following steps to remove the base:
1.
Use a long screwdriver to push the release latch located in a hole just above the stand.
2.
Once the latch is released, remove the base away from the monitor.