Setting up the monitor, Attaching the stand, Connecting your monitor – Dell P2310H Monitor User Manual
Page 30
Back to Contents Page
Setting Up the Monitor
Dell™ P2210H/P2310H Flat Panel Monitor User's Guide
Attaching the Soundbar (optional)
Attaching the Stand
To attach the monitor stand:
1.
Remove the cover and place the monitor on it.
2.
Fit the two tabs on the upper part of the stand to the groove on the back of the monitor.
3.
Press the stand till it snaps into its place.
Connecting Your Monitor
To connect your monitor to the computer:
1.
Turn off your computer and disconnect the power cable.
Connect the blue (VGA) cable from your monitor to your computer.
NOTE:
The stand is detached when the monitor is shipped from the factory.
WARNING:
Before you begin any of the procedures in this section, follow the
Safety Instructions
.
NOTE:
If your computer supports a white DVI connector, unscrew and detach the blue (VGA) cable from the monitor and then
connect the White DVI cable to the monitor and the white DVI connector on your computer.