Compaq 60002MC10 - Manual (Page 61)

Appendix
A-14
c) DST This defines the destination location for the operation:
Mode Meaning
COPY/
LOAD
Destination drive (e.g, 2 for drive two)
DUMP Disk image filename or device,(e.g, g:\images\system2.img)
PCOPY/
PLOAD
Destination partition,(e.g, 2:2 indicates the second
partition on drive two).
PDUMP Partition image filename (e.g, g:\images\part1.img).
c) SZEy Used to set the size of the destination partitions for
either a disk load or disk copy operation.
Available y Options:
F Resizes the first partition to maximum size allowed based
on file system t type.
L Resizes the last partition to maximum size allowed based on
file system type.
n=xxxxM - indicates that the n?h destination partition is to have a size
of xxxx Mb. (e.g, SZE2=800M indicates partition two is to
have 800 mb.) n=mmP - indicates that the n?h destination
partition is to have a size of mm percent of the target disk.
n=F - indicates that the n?h destination partition is to remain
fixed in size.
n=V - Indicates that the partition will be resized according to the
following rules:
Rule 1 - If the destination disk is larger than the original
source disk, then the partition(s) will be expanded to have
the maximum amount of space subject to the free space
available and the partition type (e.g, FAT16 partitions will
have a maximum size of 2048Mb.)
Rule 2 - If the destination disk is smaller than the original
source disk, (but still large enough to accommodate the
data from the source disk), the free space left over after the