Dell UPS 1920R - Manual (Page 12)

Dell UPS Management Software: Common Software Installation Scenarios
12
Configuring multiple ULNM agents simultaneously
For large installations where individual ULNM configurations would be too time consuming, install the
MUMC application on a remote computer and use it to configure multiple ULNM agents.
MUMC cannot be installed on a computer already running ULNM. If a remote computer is not available,
MUMC can be used instead of ULNM as a shutdown agent. To do this, remove the ULNM software from
the computer, install the MUMC software, and enable the Shutdown module in “System”  “Module
Settings.” Note that the “Shutdown Controller” option is not available in MUMC, so it cannot be used
as a main shutdown controller for multiple ULNM agents.
In the MUMC application:
 All ULNM agents on the same IP subnet are automatically added to the Node List. If they
do not appear or are on a different subnet, perform a manual scan: “Auto Discovery” 
“Range Scan”  ”Range Scan.”
 In the “Node Settings” menu  Shift / Ctrl + click to select multiple ULNM agents.
Figure 10: Nodes settings  Edit shutdown settings
 Edit Shutdown Settings in right hand Node Configuration menu panel:
 Click the pencil icon .
 Check the box for items you want to configure & enter required variables.
 “Apply” the settings.
 Click “Synchronize” at the top of the Node Configuration panel to send new settings to
the ULNM agents. (A mark indicates values that have not been synchronized with
the remote ULNM agent.)
 Click the Synchronize button to send settings.
For a detailed explanation of shutdown timer settings, refer to Appendix 2.