Dell PowerVault 725N (Rackmount NAS Appliance) User Manual
Page 8
1-6
Upgrading Your 39160 SCSI Card Firmware
www
.dell.com | support.dell.com
15
On the keyboard connected to the NAS system, press <F2> immediately after you see
the following message:
Press <F2> to enter the Function Select menu.
16
From the menu, select option 4, Reinstallation, and then type y to confirm the
selection.
This setup process might take several minutes.
17
When the screen warns that you are going to update the firmware, type y.
18
Press y again to confirm the selection.
19
When the screen prompts you to reboot your NAS system, do so.
The SCSI firmware update is complete.
Using a Client System Running Windows 2000 on the Same Network
If you have a client system running Windows 2000 on the same network, you can update
the SCSI firmware whether the network does or does not have a DHCP server.
Requirements
• Client system running Windows 2000 (Professional or Server Family) with a diskette
drive and a CD drive on the same subnet as the NAS system
• Resource CD included with your NAS system
• Range of available IP addresses
Procedure
To update your firmware, perform the following steps:
1
Shut down the NAS system, and do not turn it back on until instructed.
2
Turn off the client system running Windows 2000, if it is running.
3
Connect a keyboard, monitor, and mouse to the NAS system.
For information about system connectors, see your User’s Guide.
4
Turn on the client system running Windows 2000.
5
Log in to the client system with an account that has administrator privileges.