Dell PowerEdge 1400SC - Manual (Page 47)

support.dell.com Installing and Configuring SCSI Drivers 3-13
3. Select the removable-media device.
Drive status options appear as shown in Table 3-2.
.  &
'
The Read After Write Verify option is set to Hardware Level by default. This option
cannot be specified in the startup.ncf or autoexec.ncf file. However, the default can
be set on the command line. Refer to the NetWare User's Guide for information about
using the load command-line options.
The available options are defined in Table 3-3.
'
'
Mounting causes a drive to come online as a NetWare storage device. Dismounted
drives are inactive and cannot be accessed.


  

 



Volume Segments on Drive 1 Select for a list
Read After Write Verify 1 Hardware Level
Drive Light Status 1 Not supported
Driver Operating Status 1 Active
Removable Drive Mount Status 2 Mounted
Removable Drive Lock Status 2 Not Locked
1 Valid for both removable and nonremovable SCSI drives.
2 Valid for removable media only.


   !"#!$ 


 

Disabled All writes to SCSI disk drives are executed with the SCSI Write
command (0Ah or 2Ah).
Hardware Level All writes to SCSI disk drives are executed with the SCSI Write
and Verify command (2Eh) or (if this command is not supported
by the drive) with the SCSI Write command (0Ah or 2Ah), fol-
lowed by the SCSI Verify command (2Fh).
Software Level Not supported.