Dell PowerEdge 1400SC - Manual (Page 50)

3-16 User’s Guide
001 Unable to reserve hardware, possible conflict
The driver failed in its attempt to reserve the host adapter's hardware settings (that is,
direct memory access [DMA] and interrupt request [IRQ] settings). Another card in
your system may be causing a conflict with the host adapter.
002 NetWare rejected card Failed AddDiskSystem call
The driver failed in its attempt to register the host adapter with NetWare. The file
server may not have enough memory.
003 Invalid command line option entered > option
An invalid option was entered on the command line. The invalid option that was
entered is also displayed.
004 Invalid command line, please enter correctly
The driver was unable to understand the command line options that you entered. Be
sure that you have entered these options correctly.
0*  
 % %
+
 
The following error codes alert you to error conditions caused by factors related to the
host adapter:
200 No host adapter found for this driver to register
No Adaptec 78xx host adapter was found in your computer for the driver to register.
Be sure that the host adapter is properly configured and properly seated in the slot.
203 Invalid 'device' setting
You have entered an invalid slot setting on the command line. You can only enter slot
numbers for valid host adapters. If you load without the slot option, you will be
prompted to enter a valid value.
204 Invalid 'verbose' setting, use 'y'
You can only enter y for this option (verbose=y).
205 Invalid 'removable' setting, use 'off'
You can only enter off for this option (removable=off).
206 Invalid 'fixed_disk' setting, use 'off'
You can only enter off for this option (fixed_disk=off).
208 SCSI present but not enabled/configured for PCI
A host adapter is present, but its bus or device entry has not been enabled.