Dell PERC 4/SC - Manual (Page 17)

If you select the option Discover and load an additional driver, the system detects the extra unit. Perform step 4 to complete the procedure.
4. At the prompt to select a driver from the list, press <Insert> to insert the driver, which completes the procedure.
If you select the option Select an additional driver, perform steps 5 - 8.
5. After you select Select an additional driver, the Select a Driver screen displays.
6. Press <Insert> and read the instructions that display.
7. Put the driver diskette in the diskette drive and press <Enter>.
8. The system then detects a driver and installs it.
Modifying the PCI Slot Numbers for the Controllers
Perform the following steps to modify the PCI slot numbers for the controller:
1. At the command prompt, type:
C:\NWSERVER>
and press <Enter>.
2. Type
server –nss
(Not load Storage Service /modules.NLM)
3. At : Prompt (System Console), type:
load pedge3.ham
and press <Enter>.
The following supported slot options display:
l No Selection
l PCI Slot_2.1 (HIN 202)
l PCI EMBEDDED (HIN 10017)
4. Under choice, type:
0
This is for no selection.
5. At the command prompt (System Console), type
Edit Startup.ncf
NOTE: Write down the number after "HIN". In step 3, the number is 10017.