Dell PERC 4/SC - Manual (Page 20)

2. Once NetWare begins to boot, the following message displays: Press ESC to abort OS boot.
3. Press <Esc>.
4. At the command prompt, type:
C:\NWSERVER>
and press <Enter>.
5. At C:\NWSERVER>, insert a driver diskette into the floppy drive.
6. Type:
cd A:\
and press <Enter>.
7. At the A:\ prompt, type:
copy A:\*.* C:\NWSERVER\DRIVERS
and wait for the copy action to complete.
8. Change the directory and type:
cd C:
The path displays as "C:\NWSERVER".
9. At C:\NWSERVER prompt, type:
server
The operating system starts to boot.
10. To verify the driver version, at System Console (1) type:
modules Pedge3*
The driver version displays.
Installing the PERC 3/DC and PERC 3/QC Device Driver for NetWare 5.1, 6.0, and 6.5
ALERT: If you are manually installing Netware 5.1, 6.0, and 6.5 with PERC 3/DC or PERC 3/QC, you need to modify the device driver that the system
loads automatically for storage adapters. Do this before you install the PERC 3 device driver. Perform the following steps to modify the driver.
After you select the mouse and keyboard type, Netware installation automatically detects and reports the devices installed in your system.
1. Select Storage adapters and press <Enter> to modify the device driver.
One or more QL12160.HAM drivers load for QLogic QL12160.