Next steps – Dell PowerEdge FX2/FX2s User Manual
Page 12
6
Next Steps
You can customize the Aggregator for use in your data center network. To perform additional switch
configuration, do one of the following:
• For remote OOB management, enter the OOB management interface IP address into a Telnet or
secure shell (SSH) client and log in to the switch using the user ID and password to access the CLI.
The default user ID is root and the default password is calvin.
• For local management using the CLI, use the attached console connection.
• For remote in-band management from a network management station, enter the IP address of the
default virtual local area network (VLAN) and log in to the switch to access the CLI.
• In a Dell Networking OS upgrade, check to see that the Aggregator is running the latest Dell
Networking OS version by entering the show version command.
For information about how to configure software features, refer to the Configuration Guide for the Dell
PowerEdge FN I/O Aggregator on the Dell Support website at
12
Next Steps