Dell Projector 3300MP - Manual (Page 36)

Manually select signal type RGB, YCbCr, YPbPr.
Lamp Hour
Display operating hours since lamp timer reset.
Lamp Reset
Use this function only after a new lamp is installed in the projector. Select the left Lamp Reset icon (light bulb and arrow
under the icon), and press the Enter button to reset the lamp timer.
Power Saving Menu
Power Saving
Use this function to select the power saving delay period. Press "Yes" to go into the "set time" sub menu.
Set Time (Min)
Set the power saving delay period as you prefer. When the projector is not receiving an input signal for the selected period
of time, the projector will automatically enter power saving mode, and turn off the lamp. After a one-minute cooling period,
the projector will turn back on with detection of an input signal or by pressing the "Power" button. After two hours the
projector will turn off and must be turned on by pressing the power button on the control panel or remote.
Eco Mode
l Select On to operate the projector in lower power (156 Watt) for providing longer lamp life and quiter operation with
dimmer luminance output on the screen.
l Select Off to resume the operation in normal power (180 Watt).
Auto Source
The projector will always automatically search for available input signals when Auto Source is On, which is the default
setting. Press the Source button with Auto Source On to automatically search for the next available input signal. Selecting
Off will lock on the current input source. Set Auto-Source to Off to step through the different input signals manually.
Language Menu