Dell POWEREDGE R805 - Manual (Page 6)

4
Information Update
System Board Replacement – Safeguarding
Encrypted Data
If your system is configured to support the TPM feature, you can use
encryption applications to secure the contents of the hard drive(s).
NOTE:
When you use an encryption program, you are prompted to create a
recovery key during system setup. Be sure to store this recovery key. If you replace
the system board, you must supply the recovery key when you restart your system
before you can access the encrypted files on your hard drive(s).
LCD Status Messages Update
The following LCD messages listed in the "LCD Status Messages" table
in the
Hardware Owner’s Manual do not apply to your system.
• E1A15 SAS Cable B — A SAS cable B is not used on your system.
• E122F 2.5V PwrGd — This message applies to a voltage regulator
not present on your system.
System Messages Update
The following system messages are new.
Table 1-1. System Messages Update
Message Causes Corrective Actions
Invalid card found
in the LOM mezzanine
card
slot
An unsupported LAN-
on-motherboard (LOM)
card was detected in
the dedicated LOM
mezzanine card slot. Replace the invalid card
with a supported LOM
card.
TPM configuration
operation is
pending. Press (I)
to Ignore or (M) to
Modify to allow this
change which may
reset the system.
This message displays
during system restart
after a TPM
configuration command
has been entered. User
interaction is required
to proceed. This is not an error.
Select
I or M to proceed
with the TPM operation.
NOTICE:
Modifying can
prevent security. Ensure
that the configuration
change is valid.