Setup, Setting up the monitor, Attaching the stand – Dell P2311H Monitor User Manual
Page 12: Connecting your monitor
Setting Up the Monitor:Dell P2211H/P2311H Flat Panel Monitor User's Guide
file:///S|/SSA_Proposal/P2211_P2311/setup.htm[7/13/2011 12:17:55 PM]
Setting Up the Monitor
Dell™ P2211H/P2311H Flat Panel Monitor User's Guide
Attaching the Stand
NOTE:
The stand is detached from monitor when it is shipped from the factory.
NOTE:
This is applicable for a monitor with a stand. When other stand is bought, please refer to the respective stand setup guide for set up instructions.
To attach the monitor stand:
1. Remove the cover and place the monitor on it.
2. Fit the two tabs on the upper part of the stand to the groove on the back of the monitor.
3. Press the stand till it snaps into its place.
Connecting Your Monitor
WARNING:
Before you begin any of the procedures in this section, follow the
To connect your monitor to the computer:
1. Turn off your computer and disconnect the power cable.
2. Connect either the white (digital DVI-D) or the blue (analog VGA) display connector cable to the corresponding video port on the back of your computer. Do not
connect both cables on the same computer. Use both the cables only when they are connected to two different computers with appropriate video systems.
Connecting the White DVI Cable