Dell Latitude C610 - Manual (Page 21)

Display Assembly, Display Latch, and Hinge Covers: Dell Latitude C610/C510 Service Manual
file:///C|/Work%20Area%20-%20A/E%20DOC%20Posting/latc610/service%20manual/display.htm[2/1/2013 11:00:46 AM]
1 M2 x 3-mm screws (4)
2 top cover
3 center control cover
4 M2.5 x 5-mm screws (5)
5 bottom case
6 EMI shield bracket
1. Remove the hard drive .
2. Remove the center control cover .
3. Remove the keyboard .
4. Close the display.
5. From the back of the computer, remove the five M2.5 x 5-mm screws labeled "circle D."
6. Open the display assembly approximately 180 degrees and support the display assembly so that it does not open past
this position.
7. Remove the two M2 x 3-mm screws on the EMI shield bracket, which is attached to the display-feed flex cable (see
" Display Assembly ").
8. Remove the two M2 x 3-mm screws that secure the display-feed flex cable to the system board (see " Display-Feed
Flex Cable Connector ").
Display-Feed Flex Cable Connector
NOTICE: When reconnecting the display-feed flex cable connector to the system board, push down on the top left and
right ends of the connector. Pressing on the center of the connector may damage resistors and compromise EMI
protection in the computer.