Hinge covers, Removing the hinge covers, Replacing the hinge covers – Dell Latitude C610 User Manual
Page 26
Display Assembly, Display Latch, and Hinge Covers: Dell Latitude C610/C510 Service Manual
file:///C|/Work%20Area%20-%20A/E%20DOC%20Posting/latc610/service%20manual/display.htm[2/1/2013 11:00:46 AM]
On 14.1-inch SXGA+ panels, align the screw holes and place the display latch and attached bracket in the top cover.
2. Replace the two M2.5 x 5-mm screws and the two M1.7 x 3.5-mm screws that secure the display latch and bracket to
the top cover.
Hinge Covers
Removing the Hinge Covers
1. Remove the
2. Rotate the hinges forward at an angle of approximately 90 degrees to the front of the display assembly.
3. To remove the hinge covers, slide them off the hinges.
Hinge Cover Removal
Replacing the Hinge Covers
1. Attach the display assembly to the bottom case.
2. Close the display assembly.
3. Snap the hinge covers in place over the hinges.
NOTE:
The right plastic hinge cover label includes an "R," and the left plastic hinge cover label includes an "L."
The hinge cover labels face the back of the computer.
Hinge Cover Replacement