Dell PowerVault NX3600 - Manual (Page 97)

Network Configuration view the default
gateway. In Cluster Management →
Subnets to view the Primary subnet on the
client network. If the default gateway is
not in the Primary subnet, change the
default gateway. For attach to succeed,
the default gateway must be pingable.
• After an attach operation fails, the controller must
manually be reset to standby mode. This is done
by connecting a keyboard and monitor to the
controller that failed attach, and pressing the
system identification button key
, as directed
by the on-screen instructions.
Controller Taking Long Time To Boot Up After Service Pack Upgrade
Description The controller takes a long time to boot up after upgrading
the service pack of the controller firmware.
Workaround
• Connect a keyboard and monitor to the controller
that is taking a long time to boot up.
• If the system is booting, and is at the boot phase ,
let the upgrades finish. This can take up to 60
minutes to complete.
• Do not reboot the controller manually if it is in the
boot phase Executing System Upgrades.
Troubleshooting Dell NAS Initial Deployment Utility (IDU) Issues
Error Received While Running The Dell NAS Initial Deployment Utility
Description Error occurred while running the Dell NAS Initial
Deployment Utility (IDU).
Cause The error could be caused by either hardware setup,
network switch configuration, or cluster system
configurations.
Workaround If the discovery page displays a connection failure:
1. Verify that the management station running NAS IDU
has a network connection to the client switch of the
NAS cluster.
NOTE: It is mandatory that there must be no router
connecting the NAS controllers and the system
running NAS IDU.
2. Check if IPv6 is enabled on the management station
where the NAS IDU is running.
3. Connect a USB keyboard and monitor to the NAS
cluster controllers and verify that there are repeated
messages printing the controller MAC address with
a message stating Press "i" -re-install standby node".
If the failure is in the configuration NAS cluster page:
97