Dell Precision M6700 (Mid 2012) - Manual (Page 49)

Installing the Display Assembly
1. Tighten the screws to secure the display assembly in place.
2. Connect the camera and LVDS cables to the correct connectors on the system board.
3. Place the LVDS cable bracket on the computer and tighten the screws to secure it to the computer.
NOTE: LVDS cable is available in M4700 without the bracket. LVDS cable bracket is available only in M6700.
4. Route the cables through the routing channels.
5. Insert the wireless antenna cables through the routing hole on the chassis.
6. Tighten the screws at the bottom and back of the computer.
7. Route and connect the antenna cables to their connectors.
8. Install the:
a. palmrest
b. primary and secondary hard drive
c. optical drive
d. keyboard
e. keyboard trim
f. base cover
g. battery
9. Follow the procedures in After Working Inside Your Computer .
Removing the Display Hinges and Hinge Towers
1. Follow the procedures in After Working Inside Your Computer .
2. Remove the:
49