Dell Latitude 13 (Mid 2010) - Manual (Page 7)

Step 1: Arrange the cable in order to leave assembly space of new rubber.
Step 2: Peel off the double sided tape and attach the rubber bumper to the system.
Step 3: After adding the rubber bumper, re-assemble the cable.
NOTE:
The steps described below address HDD flex cable broken issue. This new solution will improve serviceability that will ease
DSP installation.
NOTE:
It is important that the onsite technician paste the rubber bumper to the right position as shown in this step in order to protect the
replacement cable from being cut by the card reader board edge.
NOTE:
Cable should be pressed back to the gap between board and HDD