Dell Crystal Monitor - Manual (Page 17)

OSD Warning Messagess
Language Allows you to set the OSD display to one of five languages: English, Espanol, Francais, Deutsch, or Japanese.
Menu Transparency Allows you to adjust the OSD background from opaque to transparent.
Menu Timer Allows you to set the time for which the OSD remains active after you press a button on the monitor.
Use the and buttons to adjust the slider in 1 second increments, from 5 to 60 seconds.
Menu Lock
Controls user access to adjustments. When Lock is selected, no user adjustments are allowed. All buttons are locked except
NOTE: When the OSD is locked, pressing the menu button takes you directly to the OSD settings menu, with 'OSD Lock' pre-selected on
entry. Press and hold button for 15 seconds to unlock and allow user access to all applicable settings.
Button Sound Turns on or off the button sound.
DDC/CI DDC/CI (Display Data Channel/Command Interface) allows a software on your computer to adjust the monitor display settings like the
brightness, color balance etc.
Enable (Default): Optimizes the performance of your monitor and provides a better customer experience.
Disable: Disables the DDC/CI option and the following message appears on the screen.
Select Yes to disable DDC/CI or No to return.
LCD Conditioning LCD conditioning helps eliminate any image retention and may take several hours.
NOTE: Severe cases of image retention are known as burn-in. LCD Conditioning does not remove burn-in.
Disable: This is the default option.
Enable: Enables LCD conditioning and the following message appears on the screen. Select Yes to proceed and No to return.
NOTE: Press any button on the monitor to terminate LCD Conditioning at any time.
Factory Reset Resets all OSD settings to the factory preset values.
The following warning messages may appear on the screen to indicate that the monitor is out of synchronization.
This means that the monitor cannot synchronize with the signal that it is receiving from the computer. Either the signal is too high or too low
for the monitor to use. See
Specifications for the Horizontal and Vertical frequency ranges addressable by this monitor. Recommended mode
is 1680 X 1050 @ 60Hz.
If the HDMI cables are not connected, a floating dialog box as shown below appears.