Dell S500 Projector User Manual

Page 60

Advertising
background image

2. Enable the 3D function when it satisfies any of the below-mentioned

conditions:

a Computer/Laptop with graphics card, capable of outputting at

120 Hz signal via VGA or HDMI cable.

b Input a suite of 3D content via Video and S-Video.

3. "3D Display" selection will only be enabled in the "Display Settings of

the Advanced Settings" menu when the projector detects either of

the inputs mentioned above.

4. 3D support and refresh rate are as below:

a VGA/HDMI 1280 x 720 120 Hz, 1024 x 768 120 Hz and 800 x 600 120 Hz
b Composite/S-Video 60 Hz
c Component 480i

5. The recommended VGA signal for laptop is Single-mode output

(Dual mode is not recommended).

3D S

YNC

I

NVERT

If you see a discrete or overlapping image while wearing

DLP 3D goggles, you may need to execute 'Invert' to get best match of

left/right image sequence to get the correct image. (For DLP 3D goggles)

P

ROJECTOR

S

ETTINGS

Select and press

to activate projector settings. The

projector settings menu provides the following options:

A

UTO

S

OURCE

Select Off (the default) to lock the current input signal. If

you press the Source button when the Auto Source mode is set to Off, you

can manually select the input signal. Select On to auto detect the available

input signals. If you press the Source button when the projector is on, it

automatically finds the next available input signal.

P

ROJECTOR

M

ODE

Allows you to select the projector mode, depending

upon how the projector is mounted.
•Rear Projection-Desktop — The projector reverses the image so that you

can project from behind a translucent screen.

Using Your Projector

60

Advertising
This manual is related to the following products: