Replacing the palm rest – Dell Studio 1537 (Late 2008) User Manual
Page 38
9.
Moving from left to right, carefully lift the palm rest along the rear edge, near the hinge brackets, then gently lift the palm rest to remove it from the
computer.
Replacing the Palm Rest
1.
Align the palm rest with the base of the computer and gently snap it into place.
2.
Connect the touch pad, fingerprint reader, and speaker connectors to the system board.
3.
Replace the eight screws on the palm rest.
4.
Replace the display assembly (see
Replacing the Display Assembly
).
5.
Replace the mini cards (see
Replacing the Mini-Card
).
6.
Replace the eight screws at the bottom of the computer.
7.
Replace the base cover (see
Replacing the Base Cover
).
Back to Contents Page
1 screws (8)
2 fingerprint reader connector
3 touch pad connector 4 speaker connector
CAUTION:
Before you begin the following procedure, follow the safety instructions that shipped with your computer.