Dell Studio 1537 (Late 2008) - Manual (Page 7)

Back to Contents Page
USB/Audio Board
Dell™ Studio 1535/1536/1537 Service Manual
Removing the USB/Audio Board
1. Follow the procedures in Before You Begin .
2. Remove the optical drive (see Removing the Optical Drive ).
3. Disconnect the two cables of the USB/Audio board from the connectors on the system board.
4. Remove the adhesive tapes from the cables securing it to the system board.
5. Remove the screw securing the USB/Audio board to the computer base cover and remove the board.
Replacing the USB/Audio Board
1. Connect the USB/Audio board cables to the system board connectors.
2. Place the USB/Audio board in position and replace and tighten the screw to secure the board.
3. Replace the optical drive (see Replacing the Optical Drive ).
Back to Contents Page
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
NOTICE: To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the
computer.
1 USB board 2 USB/Audio cables