Dell M5200 Medium Workgroup Mono Laser Printer - Manual (Page 34)

3 4 I n s t a l l o p t i o n a l m e m o r y c a r d s
w
w
w
.
d
e
ll.
co
m/
su
p
p
l
i
e
s |
su
p
p
o
r
t
.
d
e
l
l.c
o
m
Replacing the shield
Follow these steps to reattach the shield and close the doors.
CAUTION: Before performing any of the procedures listed below, read and follow
the safety instructions.
1 Grasp the shield by the tabs and align the three keyholes on the shield with the top
three screws. Holding the shield by the tabs, slide it down onto the screws. Tighten all
six screws.
2 Close the side door.
3 Close the upper door and the lower door.
4 Plug in the power cord and turn on the printer.