Dell OptiPlex GX400 - Manual (Page 11)

Back to Contents Page
Disk Drives and Media
Dell™ OptiPlex™ GX400 Service Manual
Drive Location
Removing the Floppy Drive
Replacing the Floppy Drive
Removing a CD, Zip, or Other External Drive
Replacing a CD, Zip, or Other External Drive
Removing a Hard Drive
Replacing a Hard Drive
Drive Location
Drive Locations
Removing the Floppy Drive
1. Turn off the computer and devices, disconnect them from their electrical outlets, wait at least 5 seconds, and then remove the computer cover .
2. Rotate the power supply away from the system board.
3. Remove the front panel .
4. Disconnect the DC power and interface cables from the back of the drive.
CAUTION: Before you perform this procedure, see " Precautionary Measures ."
NOTICE: Before disconnecting a device from the computer or removing a component from the system board, verify that the standby power light on the system
board has turned off. To locate this light, see " System Board Components ."