Agp card brace – Dell OptiPlex GX400 User Manual
Page 2
Back to Contents Page
AGP Card Brace
Dell™ OptiPlex™ GX400 Service Manual
Removing the AGP Card Brace
To access some components on the board, you may need to remove the AGP card brace.
1. Turn off the computer and devices, disconnect them from their electrical outlets, wait at least 5 seconds, and then
remove the computer cover
.
2. Remove the screw that secures the AGP card brace to the chassis.
Removing the AGP Card Brace
3. Rotate the brace up until the tab disengages from the card guide at the front of the chassis. Then lift the brace away from the chassis.
Replacing the AGP Card Brace
To replace the AGP card brace, perform the
in reverse.
Back to Contents Page
NOTE:
Your computer has either an AGP card brace or an
AGP card clip
.
CAUTION:
Before you perform this procedure, see "
Precautionary Measures
."