Dell KVM 1082DS - Manual (Page 46)

46 xxx | Basic Software Operation xxx
Click the Properties task button.
- or -
Right-click on the unit. Select Properties from the pop-up menu. The
Properties dialog box appears.
3 Click the RDP tab, as appropriate.
4 For servers only, in the IP Address field, enter an IP address in dot notation
or a 1-128 character domain name. Spaces are not allowed. Duplicate
addresses are allowed. You may use an IPv4 or an IPv6 address, or both an
IPv4 and IPv6 address, simultaneously.
NOTE: Dell 1081AD and 2161AD switches do not support IPv4 and IPv6
modes simultaneously.
5 In the Port field, enter a port number in the range 23-65535. If blank, port
23 is used.
6 Mark to enable or clear to disable the Use Default check box. When this
setting is enabled, the default global setting specified in Options will be
used and all other portions of the Application to Launch area are disabled.
7 Enter the directory path and name or click the Browse button to locate the
path and name.
8 Enter command-line arguments in the box below the path and name.
- or -
To insert a predefined macro at the cursor location in the command-
line, click the Insert Macro list box and select a macro from the drop-
down menu. The RCS software will automatically replace these variables
when the application runs.
9 Enable/disable the Launch in command window check box. When enabled,
the user-specified RDP application will be launched from within an OS
command window.
10 Click OK.